3 digit remote codes for DVD

Universal Remote codes for DVDs

Universal remote controls can operate audio and video devices of almost any brand. For each of your audio/video devices, you have to enter a Device specific Universal Remote Codes in the universal remote control. Programming your universal remote will allow you to use the remote with different devices, including your TV, Home theater, projector, Blu-ray, LED television, DVD player, VCR, stereo systems.

Have you ever had to juggle with multiple remotes to control your TV , Blu-Ray and Home theater, missing remotes and hours wasted searching each remote. Now with LED TV Universal Remote codes you can control all your home theater devices all with one remote, we have a quick and simple smart programming method and manual code entry method listed for your ease. Programming universal remote is tricky at times and takes little patience so, set aside some time before you start.

Make sure to hook up and power cables on all the devices you want to setup and switched them on. Next make sure the batteries are working in the Universal remotes. Note down the remote codes from the we have list provided in this article below. Nothing is more frustrating to find out that you have not hooked up power cable or universal remote batteries are bad after spending your evening on programming Universal remote.

Image

How to Program any DVD with Universal Remote Control.

Using the code(s) provided above, program the remote control directly using the following steps.

1. Enter Setup Mode

   Press and hold down the SETUP button on the remote until the red light on the remote turns on. Release the SETUP button. The red light will remain on.

   NOTE: The red light with either be a small light at the top of the remote or the power on/off button.

2. Press the device type button

   Press and release the device button on the remote for the type of device you wish to control. The red light will blink once and remain on.

   NOTE: If there is not a device button on the remote for your type of device, you can use any device button on the remote.

3. Enter the device code

   Use the number buttons on the remote to enter the first code listed below next to your DVD brand. The red light will turn off after entering the fourth digit.

4. Tests the results

   Point the remote at the device. Test the buttons on the remote to see if the device responds as you would expect. If the buttons do not operate the device, return to Step 1 above and use the next code in the list.

5. Repeat this process for your other devices

Image

This guide has covered the steps needed to pair your Universal remote with your DVD Player and has provided a list of codes that you can use to program the Universal remote with your DVD immediately. If you have any questions or concerns, please do not hesitate to leave them in the comments section below.